2.Identify the Left Upright (75), which is marked "Left." Have a second person hold the Left Upright near the Base (80).
See the inset drawing. Tie the wire tie in the Left Upright (75) securely around the end of the Upright Wire (70). Then, insert the Upright Wire into the lower end of the Left Upright as you pull the other end of the wire tie out of the upper end of the Left Upright.
3.Hold the Left Upright (75) against the Base (80). Be careful not to pinch the wires. Partially tighten three 3/8" x 4" Screws (4) with three 3/8" Star Washers (5) into the Left Upright and the Base; do not fully tighten the Screws yet.
Attach the Right Upright (not shown) in the same way. Note: There are no wires on the right side.
2 | 75 | |
| ||
70 | Wire | |
Tie | ||
| ||
Wire | 70 | |
Tie |
| |
75 |
| |
| 80 | |
3 |
| |
75 |
| |
5 |
| |
4 | Wires | |
| ||
| 80 |
8