Kathy Ireland Home WLTL23180 manual Assembly, Long Pins are at the same level, Switch Wire

ASSEMBLY

The help of a second person is recommended for assembly. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires

a phillips screwdriver and two adjustable wrenches (not included).

1.Slide the Handrail (6) onto the four welded bolts in the Base (19) as shown.

Refer to the inset drawing. Attach the Handrail (6) to the Base (19) with the four Handrail Nuts (16).

2.Lift the front of the Frame (32) and align the holes near the front of the Frame with one of the three sets of holes in the Handrail (6). Insert a Long Pin (5) into each side of the Handrail and the Frame. Make sure that both

Long Pins are at the same level.

Refer to the inset drawing. Insert a Cotter Pin (8) into the hole in each Long Pin (5). Make sure that the

Cotter Pins are fully inserted into the holes.

3.Attach the Console Plate (2) to the Handrail (6) with two of the six Console Screws (3). Feed the Reed Switch Wire (7) up through the hole in the Console Plate.

Hold the Console (1) near the Console Plate (2). Plug the Reed Switch Wire (7) into the back of the Console. Attach the Console to the Console Plate with four Console Screws (3). Be careful not to pinch the Reed

Switch Wire.

After you have attached the Console (1), insert any slack in the Reed Switch Wire (7) into the Handrail (6).

1
	6
19	6
	16
	19
	Bolts
2
5	6
	32
	5
8
5
3
	1
	3
2	7
6	3
3
	3

4