4.Insert the Reed Switch (7) into the Reed Switch Clip (14). Attach the Reed Switch Clip to the Frame (32) with the Clip Screw (13). Next, carefully pull any slack in the Reed Switch Wire out of the left Handrail (6).
Refer to the inset drawing. Locate the Magnet (15) on the left Flywheel (12). Turn the Flywheel until the Magnet is aligned with the Reed Switch (7). Make sure that there is a 1/8Ó gap between the Magnet and the Reed Switch. If necessary, loosen the Clip Screw (13) and move the Reed Switch slightly. Retighten the Clip Screw.
5.The Console (1) requires two "AA" batteries (not includ- ed). Alkaline batteries are recommended. Open the Battery Cover (33) by sliding it upward. Insert two batter- ies into the battery clip, making sure that the negative
(Ð) ends of the batteries are touching the springs in the battery clip. Insert the battery clip back into the Console and slide the Battery Cover (33) back into place.
6.Remove the backing from the Adhesive Clip (22). Press the Adhesive Clip onto the Frame (32) in the indicated location. Press the Allen Wrench (26) into the Adhesive Clip.
4 |
| Top View |
|
|
|
| |
6 |
|
|
|
13 |
|
| 12 |
| 13 | 15 | |
14 |
| 7 |
|
| 1/8Ó |
| |
32 |
|
|
|
7 |
|
|
|
5 | 33 | Battery Clip |
|
|
|
| |
1 |
|
|
|
|
| Batteries | |
6 |
|
|
|
26 |
|
|
|
| 22 | 32 |
|
|
|
|
7.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
5