2. Have a second person hold the console assembly near | 2 |
|
|
|
the Upright (111). Insert the cable and the wire harness |
|
|
| |
|
|
|
| |
extending from the console assembly through the hole in |
|
|
|
|
the top of the Upright. Attach the console assembly to the |
|
|
|
|
Upright with four Console Bolts (110) and two Star |
|
|
|
|
Washers (114). Firmly tighten the four Console Bolts. |
|
|
|
|
Next, connect the cable and the wire harness extending |
|
|
| 108 |
from the console assembly to the TV Cable (109) and the |
|
|
| |
Wire Harness (108). The connectors should slide to- |
|
|
|
|
gether easily and snap into place. If they do not, turn |
|
|
| Console |
one connector and try again. |
|
| 109 | |
|
| Assembly | ||
|
|
| ||
|
|
| 114 | 114 |
|
|
|
| 110 |
|
|
| 110 |
|
|
|
| 111 | 108 |
3. Note: For clarity, the console assembly is not shown | 3 | Cutouts |
| |
in this step. |
| |||
|
| |||
|
|
|
| 112 |
Orient the Short Panel (106) so that the indicated cutouts |
|
|
|
|
are at the top. Have a second person hold the Short Panel |
|
|
| 139 |
against the Upright (111), with the top of the Short | 140 | 108 |
| |
Panel flush with the top of the Upright. Route the TV |
| |||
|
|
| ||
Cable (109) down one side of the Short Panel, and route |
| 109 |
|
|
the Wire Harness (108) down the other side of the Short |
|
|
| |
|
|
|
| |
Panel, as shown. |
|
|
|
|
Next, hold the Long Panel (112) against the opposite side |
|
| 140 | 139 |
of the Upright (111); make sure that the top of the Long |
|
| ||
Panel is flush with the top of the Upright and that no |
| 106 |
|
|
wires are pinched. Press the Long Panel and the Short | 111 |
|
| |
Panel (106) together, and align the three holes in the |
|
| ||
|
|
|
| |
Long Panel with the holes in the three Panel Brackets |
|
|
|
|
(140). Attach the Long Panel and the Short Panel with |
|
|
|
|
three Panel Screws (139). |
|
|
| 139 |
|
|
|
| |
Firmly tighten the four Upright Bolts (113). |
|
| 140 |
|
|
|
|
| |
|
|
|
| 113 |
8