Spirit XT485 owner manual Service Checklist Diagnosis Guide

Page 33

SERVICE CHECKLIST - DIAGNOSIS GUIDE

Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common problems that may not be covered under the treadmill’s warranty.

PROBLEM

SOLUTION/CAUSE

 

 

Display does not light

1. Tether cord not in position.

 

2. Circuit breaker on front grill tripped.

 

Push circuit breaker in until it locks.

 

3. Plug is disconnected. Make sure plug is firmly

 

pushed into AC household wall outlet.

 

4. Household circuit breaker may be tripped.

 

5. Treadmill defect. Contact your SPIRIT dealer.

 

 

Tread-belt does not stay centered

The user may be walking while favoring or putting

Treadmill belt hesitates when

more weight on either the left or right foot. If this

walked/run on

walking pattern is natural, track the belt slightly

off-center to the side opposite from the belt

 

 

movement. See General Maintenance section on

 

Tread-belt Tension. Adjust as necessary.

 

 

Motor is not responsive after

1. If the belt moves, but stops after a short time

pressing start

and thedisplay shows “LS”, run calibration.

 

2. If you press start and the belt never moves,

 

then the display shows LS, contact service.

 

 

Treadmill will only achieve

This indicates motor should be receiving power to

approximately 7 mph but shows

operate. Low AC voltage to treadmill. Do not use

higher speed on display

an extension cord. If an extension cord is required

it should be as short as possible and heavy duty

 

 

16 gauge minimum. Low household voltage.

 

Contact an electrician or your SPIRIT dealer. A

 

minimum of 110 volt AC current is required.

 

 

Tread-belt stops quickly/suddenly

High belt/deck friction. See General Maintenance

when tether cord is pulled

section on lubrication.

 

 

Treadmill trips on board 15 amp circuit

High belt/deck friction. See General Maintenance

 

 

Computer shuts off when console is

Treadmill may not be grounded. Static electricity is

touched (on a cold day) while

“crashing” the computer. Refer to Grounding

walking/running

Instructions on page 3.

 

 

 

House circuit breaker trips, but not

Need to replace the house breaker with a “High In-

the treadmill circuit breaker

rush current” type breaker (see page 3 for details)

 

 

31

XT485 Treadmill

Image 33
Contents XT485 Treadmill Table of Contents Product Registration Important Safety Instructions Important Electrical Instructions Grounding InstructionsImportant Operation Instructions Safety Tether CordXT485 Assembly Instructions Console assembly 1UPRIGHT Tube AssemblyXT485 Treadmill 2CONSOLE Assembly 3BASE Covers 4PLASTIC Parts Assembly Transport Folding InstructionsHandrail Adjustments FeaturesQuick Speed & Incline Buttons ConsoleHeart Rate BAR Graph Getting Started Operation of Your ConsolePAUSE/STOP/RESET Feature Incline FeatureQUICK-START/MANUAL Operation Handrail Buttons Disable Switch Pulse Grip FeatureMile Track Calorie DisplaySelect a Program Programmable FeaturesCalorie Program User ProgramsFusion Program Dumbbell Bent Over ROW Dumbbell Shoulder Press Hill Preset ProgramsStrength Heart Rate Programs Rate of Perceived Exertion Using Heart Rate Transmitter Heart Rate Program Operation General Cleaning General MaintenanceBelt Adjustments BELT/DECKSetting TREAD-BELT Tracking Treadbelt Tracking AdjustmentBELT/DECK Lubrication Procedure Service Checklist Diagnosis Guide Calibration Procedure MANUFACTURER’S Limited Warranty