2.Have a second person hold the Base (52) in the position shown.
Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end).
Hold the Left Upright (53) so the two small holes are on top as shown. Insert two Upright Bolts (2) into the bracket on the Left Upright. Attach the Left Upright to the Base (52) with the Upright Bolts, two Upright Star Washers (9) and two Upright Nuts (75). Do not tighten the
Upright Nuts yet.
Attach the Right Upright (54) to the Base (52) in the same way.
3.Slide the two Wheel Housings (45) onto the Base (52). Attach each Wheel Housing with two Wheel Housing Bolts (13), two Wheel Housing Washers (32), and two Wheel Housing Nuts (43).
4.Position the Base (52) as close to the front of the treadmill as possible, as shown.
See drawing 4a. Insert the wire tie and the con- nector on the end of the Wire Harness (39) into the square hole in the Right Upright (54). Then, insert the Wire Harness until the wire tie is ex- tending from the upper end of the Right Upright. Secure the Wire Harness to the top of the Right Upright so that it will not fall inside.
See drawing 4b. Attach the ground wire on the Wire Harness (39) to the indicated hole in the Base (52) with a Silver Ground Screw (84).
Then, press the indicated Grommet (49) into the Right Upright (54).
2 |
|
|
|
2 | 9 |
|
|
|
|
| |
54 |
| 75 |
|
|
|
| |
| 9 |
| 9 |
Large |
| 52 | 2 |
Hole |
|
| 75 |
Small Holes |
|
|
|
|
|
| 9 |
|
| 53 |
|
3 | 32 |
|
|
45 |
|
| |
43 |
| ||
|
| ||
13 | 32 |
|
|
|
|
| |
|
|
| 32 |
|
| 45 | 43 |
|
|
| |
|
| 13 | 32 |
|
|
| |
| 52 |
| |
4 |
| 4a |
|
| 39 | 39 | 54 |
Wire Tie
54
52
4b
54
49
39 |
|
Ground |
|
Wire 84 | 52 |
7