MONO OPERATION
minimum impedance of 2 ohms
AUTO | INPUT LR | L | R |
TURN ON | SENSITIVITY | | |
+12V DC AUDIO | LO | | |
OFFSET | HI | | |
| REMOTE BASS | |
SPKR + | SPKR - | | |
+ | – | | |
| signal in | signal out |
woofer
NOTE: Speaker terminals on the ZX2500.1 are on the opposite end panel.
OPERATION
AUTO | INPUT | L | R | L | R |
TURN ON | SENSITIVITY | | | | |
+12V DC AUDIO | LO | INPUT | | OUTPUT | |
OFFSET | | |
HI | | |
| | REMOTE BASS | |
| | | |
SPKR + | SPKR - | | | | |
Automatic Turn-On Selection: The ZX series offers three different automatic turn-on modes that can be selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the REM terminal to have +12V out for turning on additional amplifi ers.
•Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18 gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the amplifi er’s positive and negative power terminals. This is the preferred automatic turn-on method.
•DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.
•Signal Sense Turn-On: The Audio setting is the fi nal alternative for Automatic turn-on. This is a Signal Sense turn-on method that detects the incoming audio signal from your source unit and automatically turns on the amp. This turn-on method will not work properly if the input gain control is not set appropriately.
2010 ZX 1000.1 1500.1 2500.1 RevD.indd 4