|
|
MODEL: | ZX1000.1 / ZX1500.1 / ZX2500.1 |
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE |
|
|
|
Model: | ZX1000.1 | ZX1500.1 | ZX2500.1 |
RMS Power |
|
|
|
@ 14.4V, 4Ω mono, ≤ 1% THD+N | 500W x 1 | 750W x 1 | 1250W x 1 |
@ 14.4V, 2Ω mono, ≤ 1.5% THD+N | 1000W x 1 | 1500W x 1 | 2500W x 1 |
Length | 20” (507mm) | ||
Specifications common to all models: |
|
| |
Height |
|
| |
Width |
|
| |
Frequency Response ± 1dB |
|
| |
>95dB, |
| ||
Input Sensitivity | Low Level: |
| |
| High Level: |
| |
Selectable Electronic Crossover | Variable |
| |
Bass Boost | Variable |
| |
Subsonic Filter | 24dB/octave, fi xed @ 25Hz |
| |
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open ventilation for the amplifi er. If possible, mount the amplifi er in the
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a
The ZX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals from your car stereo’s source unit. Ideally, when connecting the source unit to the amplifi er, the ZX amplifi er’s input level switch should be set to “LO” and a
2 | ZX AMPLIFIERS |
2010 ZX 1000.1 1500.1 2500.1 RevD.indd 2
10/15/2009 11:05:20 AM
