8. While a second person holds the console as- | 8 |
| Console |
sembly near the Pulse Bar (66), connect the |
| ||
|
| Assembly | |
Ground Wire (107) on the Pulse Bar to the |
|
| |
|
|
| |
ground wire from the console assembly. |
|
|
|
Connect the wire from the console assembly to | Ground |
| 75 |
the Upright Wire (75). Make sure to connect |
| ||
the connectors properly (see the inset draw- | Wire |
|
|
|
|
| |
ing). The connectors should slide together |
|
|
|
easily and snap into place. If the connectors |
|
|
|
do not slide together easily and snap into place, |
|
| 107 |
turn one connector and then try again. IF THE |
|
| |
CONNECTORS ARE NOT CONNECTED |
|
| Wire |
PROPERLY, THE CONSOLE MAY BE DAM- |
| 66 | 75 |
AGED WHEN THE POWER IS TURNED ON. |
| ||
Lay the wires inside the bottom of the Pulse Bar |
|
|
|
(66). |
|
|
|
9. Set the console assembly on the Left and Right | 9 |
|
|
Uprights (70, 76). Be careful not to pinch any |
| Console Assembly | |
|
| ||
wires. |
|
|
|
Attach the console assembly to the Pulse Bar |
|
|
|
(66) with six 3/4" Screws (23). Start all six |
|
|
|
Screws, before tighten them yet. |
|
|
|
|
|
| 66 |
|
|
|
| 23 | 23 | 23 |
|
|
| 76 |
|
| 70 |
10.Identify the Left Handrail Cover (68), which has | 10 |
|
|
|
|
a LEFT sticker on it. Slide the Left Handrail | Console |
|
|
| |
|
|
|
| ||
Cover onto the left Handrail (62) and up against |
| Assembly |
|
|
|
the console assembly. Tighten two Cover |
|
|
|
|
|
Screws (52) into the Left Handrail Cover and the |
| 68 |
|
|
|
Left Upright (70); be careful not to overtighten |
|
|
|
| |
| 62 |
|
|
| |
the Cover Screws. |
|
|
|
| |
Attach the Right Handrail Cover (74) in the same |
|
|
|
|
|
way. |
|
|
|
|
|
|
| 52 | 70 |
|
|
|
|
|
| 74 | |
|
|
|
| 62 |
|
|
|
|
| 52 | 76 |
|
|
|
|
| |
| 9 |
|
|
|
|