Listening to FM and MW Broadcasts
Continued
Tuning In a Station |
| |
|
| |
1 When the unit is turned on, | BAND | |
| ||
press TUNER/BAND to | TUNER | |
| ||
select tuner mode. |
| |
The unit tunes in the last station |
| |
tuned in (either FM or MW). |
| |
2 Press TUNER/BAND to | BAND | |
TUNER | ||
select the band, FM or MW. | ||
| ||
Each time you press the button, the |
|
Presetting Stations
You can preset 20 FM and 20 MW stations.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
•See “Tuning In a Station” on the left.
band selection alternates between |
2 Press PROGRAM.
PROGRAM
FM and MW. |
|
|
3 Press and hold 4 or ¢ | SEARCH/TUNING | |
|
| |
for more than 1 second. |
|
|
|
| |
|
| |
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the STEREO indicator lights up.
The PROGRAM indicator and “00” start blinking on the display.
3Press PRESET ∞ or 5 (or
PRE UP or REPEAT/PRE DOWN on the remote control) to specify the desired preset number.
PRESET 
REPEAT
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
4Wait a few seconds to confirm the preset number.
•Alternatively, press PROGRAM.
5To preset more stations, repeat the steps above, allocating a different preset number to each station.
When a new station is stored
The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.)
– 10 –