Assembly
NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled.
Step 5
Attach the Upper Back Pad (#8) & Lower Back Pad (#41) to Back Pad Support Frame (#5) using:
•four M10*70 Button Head Cap Screw (#17)
•four Φ11*Φ23*2 Flat Washer (#18)
Attach the Back Pad Support Frame (#5) to Main Frame (#1) using:
•one M12*125 Button Head Cap Screw (#12)
•two Φ13*Φ26*2 Flat Washer (#13)
•one M12 Nylon Lock Nut (#14)
Step 6
Attach the Adjustable Back Pad Frame (#6) to Back Pad Support Frame (#5) using:
•one M12*125 Button Head Cap Screw (#12)
•two Φ13*Φ26*2 Flat Washer (#13)
•one M12 Nylon Lock Nut (#14)
Attach the Nylon Spacer (#7) to Adjustable Back Pad Frame (#6) using:
• one M12*125 Button Head Cap Screw (#12)
•two Φ13*Φ26*2 Flat Washer (#13)
•one M12 Nylon Lock Nut (#14)
Step 7
Attach the Foam Tube (#31) into Front Weight Slide Holder (#29). Place Foam Padding (#32) on each side of Foam Tube (#31)- secure with Plastic Washer (#49) & Metal End Cap (#33).
Attach Front Weight Slide Holder (#29) to Main Frame (#1) using L Pin (#34).
Note: Wrench tighten bolts and
Nylon Lock nuts.
8