Sears 831.288264 instruction

6.Lubricate the Handlebar Shaft (54). Slide the Right Handlebar

(36)onto the right end of the Handlebar Shaft. (Note: Refer to the drawing on the front cover and make sure that the Right Handlebar is turned correctly.) Slide the Left Handlebar (37) onto the left end of the Handlebar Shaft. Tap a 5/8" Push Nut

(35)onto each end of the Handlebar Shaft.

7.Slide an M8 Washer (5), a Link Arm Bushing (47) and a Link Arm (26) onto the threaded pin on the lower end of the Left Handlebar (37). Make sure that the Link Arm Bushing is turned so the flange is next to the Washer. In addition, make sure that the opening in the end of the Link Arm is down- ward, as shown. Tighten an M8 Locknut (32) with an M8 Washer (5) onto the threaded pin.

Attach the other Link Arm to the Right Handlebar (not shown) in the same manner.

6
35	36
	36
	37
	54
		35
7
	37	26
	Flange	26
	Flange
	5
	47
	5	32
		32

8.For your convenience, the pedal assemblies have been pre-assembled. Remove the 1/2" Locknut (23) from one of the Pedal Shafts (16). Slide the 17.5mm Washer (56) onto the shoulder of the Pedal Shaft and firmly tighten the Pedal Shaft clockwise into the right arm of the Crank (18). Next, tighten the 1/2Ó Locknut (23) back onto the Pedal Shaft. Make sure that the 17.5mm Washer (56) can be moved back and forth on the shoulder of the Pedal Shaft. Fit the end of the right Link Arm (26) onto the Pedal Shaft and slide the Link Arm onto the Pedal Bushing (25).

Attach the other pedal assembly to the left arm of the Crank (not shown) in the same manner.

8	Shoulder
	56	16	18	23
	25	16	18	23
			26

9.Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some small hardware may be left over after the exercise cycle is assembled.