Sears 831.159370 specs

26.Attach a “V”-Pulley (6) and a Long Cable Trap (50) to the bracket on the Press Seat Frame (77) with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21). It may be necessary to place the Long Cable Trap on top of the bracket.

Make sure the Long Cable Trap is positioned as shown.

Attach two 3 1/2” Pulleys (15) and two Cable Traps

(66) to the Leg Press Arm (89) with a 3/8” x 4 1/2” Bolt (79) and a 3/8” Nylon Jam Nut (83). Make sure the Cable Traps are positioned as shown.

27.Locate the Long Cable (58). It has a closed loop on one end and a threaded tip on the other.

Attach the closed loop to the Press Upright (56) with a 5/16” x 2 3/4” Bolt (11), a 5/16” Flat Washer (8) and a 5/16” Nylon Locknut (3).

Make sure the flat side of the closed loop is turned towards the Upright.

Make sure the Long Cable is attached on the indi- cated side of the Press Upright.

Route the threaded end of the Long Cable around the “V”-Pulley (6) on the Press Frame (17) in the direction shown.

Route the Long Cable around the “V”-Pulley (6) on the Press Upright (56) in the direction shown.

Route the Long Cable around the 3 1/3” Pulley (15) on the Press Upright in the direction shown.

28.Route the Long Cable (58) around the indicated 3 1/2” Pulley (15) on the Leg Press Arm (89) in the direction shown.

Route the Long Cable around the “V”-Pulley (6) on the Press Seat Frame (77) in the direction shown.

26		83
89	66	83
15
		21
66		77
		77
		50
79		6
	7
27
	17
6
		3
58
		8
22		6
56
	15
28
77		15
77
	6
		89