HOW TO REMOVE THE SIDE SHIELDS AND THE FLYWHEEL COVERS
The Left and Right Side Shields (15, 16) must be removed before the reed switch or the drive belt can be adjusted. To remove the Side Shields, remove the indicated Screws (48, 94, 95). Note which hole each Screw is removed from; the Screws will later need to be reattached in the same holes. Carefully separate and remove the Side Shields.
16 | 95 |
|
95 | 48 | 94 |
| ||
15 |
|
|
94 |
|
|
Next, the Right |
| 19 | 18 |
and Left |
| ||
Flywheel Covers |
|
|
|
(18, 19) must be | 48 |
| 69 |
removed. |
| ||
Remove the |
|
|
|
indicated |
|
|
|
Screws (48, 69, | 69 |
|
|
25) from the |
|
| |
Flywheel | 25 |
|
|
Covers. Note | 69 |
| |
which hole each |
|
| |
Screw is |
|
|
|
removed from; the Screws will later need to be reat- | |||
tached in the same holes. Carefully separate and | |||
remove the Flywheel Covers. |
|
| |
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first see the instructions at the left and remove the side shields and the flywheel covers.
Next, see the drawing below. Locate the Reed Switch (55). Turn the Left Crank Arm (34) until the Magnet
(37) is aligned with the Reed Switch. Loosen, but do not remove, the indicated Screw (94). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Left Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjust- ed, reattach the side shields and the flywheel covers.
| 39 |
|
37 94 |
| 34 |
|
| |
55 | 74 | 75 |
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first see the instructions at the left and remove the side shields and the flywheel covers.
Next, see the drawing above. Loosen the indicated Bolt (75). Turn the indicated Screw (74) clockwise until the Drive Belt (39) is properly tightened, and then retighten the Bolt (75). Then, reattach the side shields and the flywheel covers.
19