Repeat this step for the right Pedal | NordicTrack NTEL7506.0

12. Apply a generous amount of grease to the axle	12
on the Left Upper Body Leg (24) and to the axle	12
on the Left Upper Body Leg (24) and to the axle		24
on the left Crank Arm (55). Then, apply grease		24
to two Large Wave Washers (102).			32
		Grease
Slide an Upper Body Leg Spacer (9) and a
Large Wave Washer (102) onto the Left Upper		102	9
Body Leg (24). Make sure that the flat side of		31
the Upper Body Leg Spacer is facing out-		31
the Upper Body Leg Spacer is facing out-
ward. Then, slide the other Large Wave Washer	66
onto the left Crank Arm (55).
Slide the left Pedal Arm (32) onto the Left Upper	86	95
Slide the left Pedal Arm (32) onto the Left Upper		32
Body Leg (24) while sliding the left Link Arm		32
Body Leg (24) while sliding the left Link Arm
(30) onto the axle on the left Crank Arm (55).
Attach the Pedal Arm (32) to the Left Upper			30
Body Leg (24) with an M8 x 23mm Button			30
Body Leg (24) with an M8 x 23mm Button
Screw (86), an M8 Washer (95), an Axle Cover
(66), and an M8 x 23mm x 1mm Washer (31).
Then, attach the Link Arm (30) to the Crank Arm
(55) with an M8 x 23mm Button Screw (86), an
M8 Washer (95), a Large Axle Cover (52), and
an M8 x 23mm x 1mm Washer (31).
Repeat this step for the right Pedal		30	102
			102

Arm (32) and the right Link Arm (30).			31
		95	55
See step 4. Tighten the M8 x 19mm Button		95
See step 4. Tighten the M8 x 19mm Button			Grease
Screws (85).			Grease
Screws (85).			52
		86	52
		86

13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.