3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an Incline Axle Screw (30). Tighten the Incline Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle.
Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline
Frame is turned so the
Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other Incline Axle Screw (30). Tighten the Incline Axle Screw into the open end of the Incline Axle (29).
4.Attach the Incline Bracket (24) to the lower end of the Upright (2) with the M10 x 85mm Bolt (25) and an M10 Nylon Locknut (26). Do not overtighten the Nylon
Locknut; the Incline Bracket must pivot easily.
5.The Console (87) requires two “AA” batteries (not included). Alkaline batteries are recommended. To install batteries, turn the Console face down and remove the Battery Cover (97), as shown in the inset drawing. Next, insert two batteries into the Console.
Make sure that the negative ends of the batteries (marked
Carefully feed the Resistance Cable (57) down through the Upright (2) until the end of the Resistance Cable extends from the bottom of the Upright. Next, connect the console wire to the Extension Wire (51).
Attach the Console (87) to the Upright (2) with the four Console Screws (35) and the four Console Washers
(98)packaged with the Console. Be careful to avoid pinching the wires.
Snap the bookrack onto the Console (87) where shown.
6
3 |
|
|
|
|
|
|
|
| |
|
|
|
| 5 |
|
|
|
| 58 |
|
|
|
| 33 |
|
|
|
| 30 |
Grease | 29 |
| Tubes | |
|
|
|
| |
58 | 33 |
|
|
|
|
|
|
| |
30 |
|
| 1 |
|
|
|
|
| Tubes |
4 |
|
|
|
|
|
|
|
| 2 |
|
| 24 | 26 |
|
| 25 |
|
|
|
5 | 87 |
|
|
|
|
|
|
| |
97 |
|
|
| Bookrack |
Console |
|
|
| |
Wire |
|
|
|
|
51 |
|
| 57 |
|
|
|
|
| |
98 |
|
| 2 | 97 |
|
|
| ||
|
|
|
| |
|
|
|
| 87 |
35 | 35 |
|
|
|