PLS2

6.Attach the Upper Handrail (122) to the Uprights (69) with two 3” Bolts (125) and two Handrail Washers (124). Firmly tighten the Bolts.

7.Make sure that all parts are properly tightened be- fore you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 28). To protect the floor or carpet from damage, place a mat under the treadmill.

6
122
	69
125	124
125	125

If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.

Make sure that the power cord is unplugged.

See step 6 above. Remove the two 3” Bolts (125), the two Handrail Washers (124), and the Upper Handrail (122).

1.Remove the indicated screws from the Console Back (88).

(Important: The screws may be different lengths; re- member which hole each screw was removed from.) Next, remove the Console Back.

2.Peel the paper off the pad on the bottom of the receiver

(A). Turn the receiver so the small cylinder is on the side shown, and press the receiver onto the Console Base (81) in the indicated location.

1	82
	82
	88
	Screws
2
	A

Cylinder

3.Connect the included short jumper wire (B) to the wire on the receiver (A). Connect the other end of the short jumper wire to the PLS2 jack on the underside of the Console (82). (Note: If there is already a wire in the PLS2 jack, unplug it.) Discard the other wires included with the receiver. Use the included wire tie to secure the wires, if needed.

Make sure that no wires are pinched. See step 1. Reattach the Console (82), making sure that the screws are inserted into the same holes from which they were removed. See step 6. Reattach the Upper Handrail (122).

Jack