STEP 1 – Vertical Column Assembly
Lift up the Vertical Column Tube and insert into Base Frame Assembly. When lifting the Vertical Column Tube, be sure you don’t cut wires.
It is critical that you line up the sticker on the Vertical Column Tube and Main Frame to assure proper alignment.
Insert the six M8 x 15mm Allen Bolts, M8 Spring Washers and M8 Curved Washers, finger
tighten. Once all Bolts are inserted you must tighten with the long Allen Wrench provided.
1 | vertical column tube |
alignment
stickers
base frame assembly
STEP 2 – Rear Caps/Front Rollers Assembly
Carefully lay the unit on its side. Remove the orange Shipping Plugs by prying them out with a Screwdriver. Put Rear Caps and Front Rollers on the appropriate ends of the Base Frame Assembly that are facing up. Aligning the notches in the Base Frame Assembly with the notches in the Rear Caps and Front Rollers, insert the two M6 x 20mm Phillips Screws and tighten with the
Screwdriver provided.
example
align
notches
front roller
M6 x 20mm phillips screws
Lay the Unit on the other side and repeat. | place |
Stand unit back up to proceed. | |
2 | screw |
here |
front bottom view of base frame assembly
6