_LLL
_LLLL LLLLLLLLLLLLLL
_LLLLLLLLLLLLLLLLL
.LLLLLLLLLLLLLLLLLLLLLLLL LLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
.LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL[ LLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
_LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL[ _LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLL LLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLL _LLLLLLLLL
L
~1/2 X 5"
FIGURE 2
STEP 2:
¯Insert four 1/2" FLANGEBEARINGS(46) into the BUSHINGSon the BASE(1), and four 1/2" FLANGEBEARINGS(46) the BUSHINGSon the PLATFORM(11) as shown in FIGURE
¯Assemble the PLATFORM(11) between the BUSHINGSon the BASE(1) as shown in FIGURE2 using two 1/2 X 5" BOLT'3
"T
andtwo 1/2 LOCKNUS (33). (TIGHTEN THE CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWING THE PLATFORM TO ROTATE FREELY)
STEP3:
¯Attach four
¯Thoroughly clean all surfaces where the PARAGLIDE STRIPS(27) are to be attached.
¯Removethe PARAGLIDESTRIPS(27) from the paper backingand firmly apply them to all shownsurfaces.
SECURELYAssemble one 1/2" DIA. SPRINGPIN (47) to the SPRINGPIN HOUSING,on the PLATFORMSLEEVE(2) showninFIGURE 3. (!!! IMPORTANT!!! TIGHTENTHE
NUT OF THE SPRING PIN SECURELY)
FIGURE 3