ParaBody 893102 manual Prosystem Assembly Instructions, Top Boomweld~~Ient Pre-Assembl Y

893102 PROSYSTEM ASSEMBLY INSTRUCTIONS

Assemble the appropriate ENDCAY~Sto the UPRIGHTFRAMEWELDMENT..BENTTUBE. and the

LOWROWATTACHMENTWELDMENTas shown, also attach the 5-1/2 X 2-1/2 IN. NONSKID STRIPS to the LOWROWATTACHMENTas shown.

SECURELY assemble the LOW ROWATTACHMENTWELDMENTand the UPRIGHT FRAME ~VELDJ~IENTto the BENTTUBEas shown.

LOOSELYassemble the UPRIGHTWELDMENTSto the BENT TUBE as shown.

Attach eight (8) 1 IN. SQ. GLIDESto the CARRIAGEWELDMENTas shown in (DETAIL A) also attach the 1-1/4 SQ. RUBBERBUMPERto the CARRIAGEWELDMENTas shown, then proceed to

slide the CARRIAGEWELDMENTdown over the UPRIGHTFRAMEWELDMENTas shown..

Attach the 1-1/2 X 3/4 IN. GLIDES. and the THUiV~SCREWSto the SAFETYRAILWELDMENTSas

shown in (DETAILB), also assembie two (2) SPRINGPIN ASSEMBLIESto the SAFETYRAIL WELDMENTSas shown in (DETAIL D), then proceed to slide the SAFETYRAILWELDMENTSdown

over the UPRIGHTWELDMENTSas shown.

TOP BOOMWELD~'~IENT PRE-ASSEMBL Y:

A.Route CABLE(6576201) through the front slot and downte the rear slot of the TOPBOOM WELDkIENT.

B.LOOSELYassemble three (3) 3-1/2 X 1 IN. PULLEYSwith FLANGESPACERSto the TO_...__P BOOM ~VELDMENTas shown. (NOTE: MAKESURE CABLE IS IN THE GROOVEOF THE PULLEYS)

C.Assemble the 3 X 2 IN. ENDCAP to the TOPBOOMWELDMENTas shown.

D. When the TOP BOOMWELDMENTPRE-ASSEMBLYis complete, LOOSELYassemble it to the UPRIGHT FRAME WELDMENTas shown.

4

12/06/95