ParaBody 893102 manual LOW Pulley Cable Routingassembl Y see Cable ROUTINGDIAGRA3~I

893102 PROSYSTEM ASSEMBLY INSTRUCTIONS

17.LOW PULLEY CABLE ROUTINGASSEMBL Y (SEE CABLE ROUTINGDIAGRA3~I)."

ho

Eo

Route CABLE(657620 i) under and around the PULLEYSat the bottom of the UPRIGHT FRAy'vIE WELDMENT. (NOTE: AFTER CABLE HAS BEEN ROUTED UNDER PULLEY, POSITION CABLE RETAINING CLIP UNDER THE PULLEY AS SHOWN

AND TIGHTEN)

Route CABLEup and around the bottom PULLEYof the 1-3/4 X 5-1/4 IN. PLATESas shown. and down to, and around the PULLEYunder the PULLEYBRACKETWELDMENT(SEE.

NOTE ABOVE)

Assemble the end of the CABLEto the PULLEYBRA CKETWELDMENTas shown. SECURELYassemble the appropriate HARDWAREtothe hole below the front PULLEYat the

bottom of the UPRIGHTFRAMEWELDMENTas shown. SEC.URELYtighten all remaining PULLEYCONNECTIONS.

18.Slide the 1 X 8 IN. GP, dPS over the ends of the LATBARWELDMENTand LOWROWBAR

WELDMENTas-shown. (TIP: USE WINDOWCLEANERON TIlE INSIDE OF TIlE GRIPS TO HELP EASE ASSEMBLY)

19.SEE CABLE ROUTING DIAGRAM FOR THE COMPLETE USE AND LOCATION OF THE LA T BAR WELDMENT, CHAIN, AND LOWROWBAR.

20.Attach the UP1KIGHTLABELSto the UPRIGHTWELDMENTSas shown.

6

12/06/95