ParaBody 220 manual Found in the Shroud KIT BOX into the Base

STEP 4:
• Insert two GUIDE RODS (16) into the BASE (2) as	48
shown on FIGURE 4. (NOTE: If the 220 SHROUD
OPTION was purchased, place the GUIDE RODS
(16) through the BOTTOM SHROUD BRACKET
(FOUND IN THE SHROUD KIT BOX) into the BASE	16
(2), as shown in FIGURE 4.

•(NOTE: Lubricate GUIDE RODS (16) with silicon or teflon spray available at most hardware stores.)

•Slide the following items in order down each GUIDE

	ROD (16), one WEIGHT STACK SPACER (45), one		HEAD
	3/4” FLAT WASHER (38) and one WEIGHT STACK
			PLATE
	CUSHION (46)
			ASSY
• Using EXTREME CARE slide all fifteen
	WEIGHT PLATES (22) down the GUIDE RODS (16)
	onto the WEIGHT STACK CUSHIONS (46). Make sure
	that the keyholes of the WEIGHT PLATES (22) are all
	facing the right way.
•	Slide the head plate assembly down GUIDE RODS
	(16) onto the weight stack.
•	Slide one SHAFT COLLAR (48) down each		46
	GUIDE ROD (16).		38
	5	4	45
			220 SHROUD
			BRACKET
	30 3/8 X 3-3/4		OPTION ONLY

FIGURE 4

	34
53
FIGURE 5	16

STEP 5:

2

•Carefully slide the RIGHT (5) and LEFT (4) BOOM PLATES onto the GUIDE RODS (16 )as shown in FIGURE 5 and loosely assembly BOOM PLATES (5), (4) to frame (1) using two 3/8 x 3-3/4” BOLTS (30) and two 3/8” LOCK NUT (34)

[CAUTION MUST BE TAKEN NOT TO PULL GUIDE RODS (16) OUT OF BASE (2)]

•Screw ADJUSTABLE GLIDE (53) approximately 1/2” into FRAME (1) and tighten jam nut securely as shown

8