4.Attach the Handlebar (7) to the Handlebar Post (6) with three M8 x 25mm Button Screws (19) and three M8 Split Washers (28). Make sure to feed the Upper Wire Harness (16) and the Pulse Sensor Wires (71) through the indicated hole in the Handlebar.
5.While another person holds the Console (9) near the Handlebar (7), connect the Pulse Sensor Wires (71) to the console wires. Next, plug the Upper Wire Harness (16) into the socket in the back of the Console.
Insert all excess wiring down into the Handlebar Post (6). Attach the Console (9) to the Handlebar
(7)with four M4 x 16mm Screws (21). Be careful to avoid pinching the Pulse Sensor Wires (71) or the Upper Wire Harness (16).
6.Attach the Seat (12) to the Seat Post (11) with four Seat Screws (29) and four M8 Flat Washers (18).
Note: The Seat Screws and Flat Washers may be
Using an adjustable wrench, remove the Seat Knob Assembly (31) from the Frame (1).
Insert the Seat Post (11) into the Frame (1). Slide the Round Collar (13) down the Seat Post and press it into the Frame. Secure the Round Collar to the Frame with an M6 x 8mm Screw (26).
Reattach the Seat Knob Assembly (31) to the Frame (1).
6
4 |
| |
| Hole | |
| 71 | |
| 7 | |
6 |
| |
28 |
| |
19 | 16 | |
28 | ||
| ||
| 19 | |
5 |
| |
| 9 | |
7 | 71 | |
Console | ||
| ||
| Wires | |
| 16 | |
| 6 | |
21 |
| |
6 |
| |
| 12 | |
| 11 | |
13 |
| |
| 18 | |
1 | 29 | |
| 26 | |
| 31 |