If your audio source has a
.+56'0+0)"5#('.;
To protect your hearing, follow these guidelines when you use your headphones.
•Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level.
•Do not listen at extremely high volume levels. Extended
•Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing.
75+0)";174"*'#&2*10'5
You can use multiple sets of headphones with each transmitter. We do not recommend using multiple transmitters in the same area.
1.Press POWER on the transmitter. The transmitter’s POWER indicator lights red. Turn on the audio source.
2.To turn on the headphones, slide POWER away from the headband. The POWER/BATT LOW indicator lights red.
3.Put on the headphones and adjust VOLUME to the desired listening level.
4.To turn off the headphones, slide POWER toward the headband.
5.To turn off the transmitter, press the power switch. The POWER indicator turns off.
±"016'"±"
•If the POWER/BATT LOW indicator is blinking, the battery level is low and you must replace the alkaline batteries or recharge the rechargeable batteries before use.
•If you connected the transmitter to an audio source’s headphone jack, set the audio source’s volume control to its mid- position, then adjust VOLUME on the headphones to the desired level.
•To preserve battery life, be sure to turn off the headphones when you are not using them.
•If reception is poor even when the batteries are fully charged and you are near the transmitter, try moving the transmitter to a higher location or moving it away from the audio source.
•If you are not using the transmitter, disconnect the adapter.
•Turn off the headphones before turning off the transmitter.
Using Your Headphones
5