Assembly

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included

tools, assembly requires a Phillips screwdriver , an adjustable wrench , and

a rubber mallet .

As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been pre-assembled.

		M4 x 16mm
M6 Washer	M8 Split	Round Head	M8 x 16mm Button	M8 x 19mm Button
(44)–7	Washer (55)–14	Screw (80)–4	Screw (54)–6	Screw (77)–4
M6 x 42mm Button		M6 x 38mm Button	M8 x 50mm Button
Screw (81)–4		Screw (72)–3		Screw (52)–4
		M10 x 63mm Bolt Set (62)–1

1.Orient the Left Front Stabilizer (15) with the Wheel (17) positioned as shown. Attach the Left Front Stabilizer to the left side of the Frame (1) with three M8 x 16mm Button Screws (54) and three M8 Split Washers (55).

Attach the Right Front Stabilizer (not shown) to the right side of the Frame (1) in the same way.

1
17	15
	1
	55
	55
	54
	54