ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the includ-
ed tools and your own adjustable wrench 
and Phillips screwdriver
.
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below each drawing refers to the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it has been preassembled.
M6 Nylon | M8 Nylon |
| M10 Nylon | M8 Split | M10 Black Split | |
Locknut | Locknut | Locknut | Washer | Washer | ||
M10 Bright Split | M4 x 15mm | M4 x 15mm | M4 x 25mm | M6 x 40mm Button | ||
Washer | Screw | Screw | Screw | Bolt | ||
M10 x 20mm Button |
|
| M10 x 73mm Button Bolt |
| ||
Screw |
|
|
|
|
| |
1.Identify the Front Stabilizer (2), which is narrow- er than the Rear Stabilizer (not shown). While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 73mm Button Bolts (33) and two M10 Black Split Washers (34).
1
1
2
34
33
5