MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
Right Side Shield. Using an adjustable wrench, turn the Right Pedal (37) counterclockwise and remove it. Next, turn the Right Crank Arm (27) so that it is point- ing toward the front of the exercise cycle, and then slide off the Right Side Shield.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console displays flicker or darken, increase your pedaling pace. If the console does not display your heart rate when you use the handgrip pulse sensor, refer to step 5 on page 11.
HOW TO LEVEL THE EXERCISE CYCLE
Next, turn the indicated M8 Nylon Locknut
(56)until the Drive Belt (69) is properly tightened. Then, reattach the right side shield and the right pedal.
69 |
56 |
HOW TO ADJUST THE REED SWITCH
If the exercise cycle does not sit flat on the floor, turn one or both of the leveling pads until the exercise cycle is level.
Leveling |
Pads |
If the console does not display correct feedback, the reed switch should be adjusted. Refer to HOW TO ADJUST THE DRIVE BELT at the left. Remove the indicated M4 x 38mm Screws (30) from the Right Side Shield (5) and the M4 x 16mm Screws (not shown) from the Left Side Shield (4). Using an adjustable wrench, turn the Left Pedal (not shown) clockwise and remove it. Turn the Left Crank Arm (34) so that it is pointing toward the front of the exercise cycle, and then slide off the Left Side Shield.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the Drive Belt (not shown) may need to be adjusted. To adjust the Drive Belt, the Right Side Shield (5) must first be removed. Remove the indicated M4 x 38mm Screws (30) and M4 x 16mm Screws (21) from the
37 |
5 |
4 |
27 |
30 |
21 |
Locate the |
|
| |
Reed Switch | 34 |
| |
(44). Turn the |
| ||
|
| ||
Left Crank |
|
| |
Arm (34) until |
|
| |
the Magnet |
|
| |
(75) is aligned |
|
| |
with the Reed | 44 | 75 | |
Switch. | |||
21 |
| ||
Loosen, but |
| ||
|
| ||
do not |
|
| |
remove, the |
|
| |
indicated M4 x |
|
| |
16mm Screw |
|
| |
(21). Slide the |
|
| |
Reed Switch slightly closer to or away from the | |||
Magnet. Then, retighten the Screw. Turn the Left Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the left pedal.
20