Reebok Fitness RBTL09506.0 manual Make sure that no wires are pinched. See

11. With the help of a second person, carefully	11
lower the Uprights (85) to a vertical position.
Attach the Right Base Cover (86) with three 3/4”
Screws (7) and two Base Cover Screws (63).
Start all five Base Cover Screws before tight-	85
ening them. Be careful not to overtighten the
Base Cover Screws. Attach the Left Base	7
Cover (88) in the same way.
With the help of a second person, carefully raise	88
the Uprights (85) to a vertical position.
	63
	7
	86
	63

12.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 28). To protect the floor or car- pet from damage, place a mat under the treadmill.

If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1. Make sure that the power cord is unplugged.		1		105
	Remove the indicated 3/4” Screws (7) from the
	back of the Console Base (98).
					98
			7		7
		7	7	7	7
					7
2.	While a second person holds the Console (105),	2
	connect the wire on the receiver (A) to the indi-			Wire
	cated wire extending from the Console. Next,
				A
	hold the receiver so the small cylinder is ori-
	ented as shown and is facing away from the
	Console. Attach the receiver to the Console in
	the location shown with the two included Small
	Screws (B).
3. Make sure that no wires are pinched. See					98
					105
	drawing 1. Reattach the Console (105) to the
	Console Base (98) with the 3/4” Screws (7).
	Discard the other wires included with the re-		Cylinder	B
	ceiver.
		10