Reebok Fitness RBEX3976.0 manual Rear Wire Harness 51, which also has a tag

9. While another person holds the Seat Bracket (11) near	9
the Seat Carriage (41), connect the Right Controller
Wire (93), which has a tag attached, to the wire on the	Avoid pinching and
Rear Wire Harness (51), which also has a tag	damaging the wires.
attached. Then, connect the Left Controller Wire (98)
to the Rear Wire Harness. Make sure the connectors
on the Controller Wires (93, 98) are positioned side
by side under the plastic cover on the Seat
Bracket.
Attach the Seat Bracket (11) to the Seat Carriage (41)				77
with four M8 x 19mm Button Screws (77) and four M8
				55
Split Washers (55).
				Plastic
	11		98
				Cover
		55	93
	77
			41
				51
10. Identify the Left Pedal (22), which is marked with an	10
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank
Arm (24). Tighten the Right Pedal (not shown) clock-
wise into the Right Crank Arm (not shown). Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten	25
the Pedals.	22
Adjust the Left Pedal Strap (25) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (22). Adjust the Right
Pedal Strap (not shown) in the same way.	24

11.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.

7