JVC FR-DS100 manual Presetting WS broadcasters and radio stations, Clearing WS broadcaster presets

Presetting WS broadcasters and radio stations

20 stations in each radio band and 20 broadcasters in the WS band can be preset. Radio bands can be preset either automatically or manually. WS band broadcasters must be manually preset.

To preset stations automatically (radio bands only)

This function scans a selected band (AM (MW/SW), FM) and can automatically store up to 20 presets in memory for each band.

1Press BAND to select the frequency band.

BAND

To preset stations and WS broadcasters manually

This function is necessary to preset WS broadcasters or radio frequencies that require manual tuning to be received.

1Select the station or WS broadcaster program to be preset.

2Press MEMORY/CANCEL.

The MEMORY indicator lights in the display and the PRESET indicators blinks.

	STEREO	MEMORY
MEMORY	WS
/ CANCEL		PRESET
	=

2Press the AUTO PRESET button to enter the automatic memory mode.

The MEMORY and the PRESET indicators blink in the display. If no buttons are pressed for 5

seconds, the mode is exited.

AUTO PRESET

AUTO STEREO MEMORY

3Press the PRESET–/PRESET+ buttons to select a preset location.

If neither button is pressed for 5 seconds, the MEMORY indicator disappears from the display

and the mode is exited.

PRESET

=

PRESET

4Press MEMORY/CANCEL again to memorize the preset.

The preset is stored in memory, and the mode is exited.

3Press PRESET–/ PRESET+ to select the preset number to begin memorizing presets at.

PRESET

4Press the AUTO PRESET button again.

The search begins automatically at the currently

selected frequency.

AUTO PRESET

MEMORY / CANCEL

Clearing WS broadcaster presets

If you move from one WorldSpace service area to another, broadcasters that were previously preset may no longer be received. Follow the procedure described below to clear broadcaster preset information in the unit.

5When a broadcasting signal is found, the search pauses and the signal is received for 5 seconds. At the end of this time, a preset for that frequency is memorized and the search continues for the next preset. However, if the AUTO PRESET button is pressed during this time, a preset is not memorized and the search continues to the next available frequency.

When the search is finished, the last preset frequency stored is tuned.

Notes:

•When the AUTO PRESET function is performed, presets previously stored will be replaced by the new presets.

•If the signal of a station is not strong enough, the search may not stop at that frequency when using the AUTO PRESET function. When this occurs, tune to the station manually and store the preset using the manual preset method shown on the next column.

While the unit is on, press and hold the WS button and then the button for 2 seconds until “INITIAL” appears in the display. All WS band broadcaster presets are cleared. Radio station presets are maintained in memory. Press the button to turn the unit to standby and then on again to complete the procedure.

WS

+

12