Leg Raise

1.Assembly Instructions

2.Position the BACK PAD (7) over the top of the UPRIGHTS (2 & 6) as shown. Secure the top of the BACK PAD BRACKET (A) using two M10 x 25mm BOLTS (8) and PLATES (9).

Do not tighten the bolts at this time.

Secure the sides of the BACK PAD BRACKET (A) using four M10 x 25mm BOLTS (8), FLAT WASHERS (4) and NYLOCK NUTS (5).

Tighten all UPRIGHT and BACK PAD BOLTS and NUTS securely.

3.Open the air valve in the center and rear of the BACK PAD (7). Using the supplied air pump, inflate the BACK PAD to an overall height of 9”. Quickly remove the air pump nozzle and close the air valve.

Insert LARGE HOLE PLUG (10) into the access hole in the rear of the BACK PAD (7).

4.Insert SMALL HOLE PLUGS (11) into the access holes in the sides of the UPRIGHTS (2 & 6).

5.Attach the RIGHT ARM PAD (12) using two M10 x 25mm BOLTS (8) and FLAT WASHERS (4) as shown. Repeat to attach the LEFT ARM PAD (12). Tighten the BOLTS securely.