assembly

MOUNTING BAND SAW/SANDER ON LEG SET

NOTE: For illustrative purposes, the Band Saw is shown mounted on the Craftsman Catalog No. 9-22236 Steel *Leg Set. This Leg Set is included with Model No. 113.243311.

1.Remove the Band Saw cover by applying gentle side

pressure on the spring tabs and release the top portion of the cover by pulling it away from the frame. Repeat procedure for bottom portion of cover

NOTE: Check the bolts which hold the feet to the Band Saw as shown. Make sure they are tight.

2.Place the Band Saw on the Steel Legs, position as

shown and align the mountmg holes in the feet of the Band Saw with those in the END STIFFENERS (marked with an X in the illustration),

3, Mount saw to legs using four (4) 5/16-1BXl " hex head

screws, Iockwashers, and hex nuts. Tighten screws.

iNSTALLING MOTOR, PULLEY, V-BELT,

AND BELT GUARDS

1.Locate the following parrs:

Qty. Description

1 Motor

1 -L'" Bracket

LE FT

FOOT \

CHECK BOLTS

FOR

TIGHTNE_

©

00

°° 0

©

©©

o o

MOTOR

_ARD

RIGHT

FOOT

 

o

0 0

 

0 o

 

0

o

 

 

Oo

 

 

0

FRONT

OF

 

SAW HERE

0o0

SUPPORT AT

THIS END

 

SUPPORT

1Small Pulley (approx. 2-1/2" Dia.)

1Large Pulley (approx. 5" Dia )

1Woodruff Key 3/16"'

1V-Belt 1/2 x 52

1Motor Cord Clamp

4Carnage Bolt 5/16-18 x 3/4

4Flat Washer 5/16 I.D.

4Lockwasher 5/16 I.D.

4Hex Nut 5/16-18

2Guard Assembly including a guard support, guard

support bracket, self-threading screws, and clips,

2.Fasten a belt guard support to the band sawframewith

self-threading screws

3.Install clJ ps onto the guard support with long end facing you.

"_._./_ / /2 _ __-.N\l

SHAFT __-_

/

/

SELF-THREADING SCREW

Page 8
Image 8
Sears 113.2433 manual Installing Motor, Pulley, V-Belt, Belt Guards, LE FT Foot, Right Foot