14.Route motor cord up and around front leg and along backside of saw frame.

Plug motor cord into outlet on upper section of band saw frame and secure cord with the cord clamp and screw.

INSTALLING SAWDUST ELBOW

1.Remove the Band Saw cover by applying gentle side pressure on the spring tabs and release the top portion of the cover by pulling it away from the frame. Repeat procedure for bottom portion of cover.

2.Find the sawdust elbow, the clamp, the strip of rubber

gasket, and two 10-32 x 3/8" self-threading screws among the loose parts.

3.Place the elbow in the opening at the bottom left-hand side of saw as shown, and attach the clamp with the two screws.

4.Peel off the protective covering from the rubber gasket and stick it around the clamp. Make sure it extends a little beyond each end of the clamp.

The gasket will help to prevent sawdust from leaking out.

For the most efficient removal of sawdust, attach a

Craftsman Vac to the sawdust elbow.

SELF-THR EADING

SCREW

,%

CLAMP

SAWDUST ELBOW

RUBBER GASKET

( \

I1

Page 11
Image 11
Sears 113.2433 manual Installing Sawdust Elbow, SELF-THR Eading Screw Clamp Sawdust Elbow Rubber Gasket