Sears 113.2433 manual Assembling Steel Legs, For Mounting, Abc, Support HEX NUT LEG SCR EW

THE FOLLOWBNG PARTS' ARE iNCLUDED WiTH

MODEL I 13,24331 1 ONLY.

totem				Description			Qty.	1
								I
A	Nut,	He×	Head 1/2-13				8	I
A	*NutHex		1/4-20		..............		32	1
B	"Screw	Truss		Hd. 1/4-20 x		5/8	32
C	Lockwasher,			1/4	External	.......	32
D	" Foot,	Leveling					4
E	Motor	.....................					I
F	Leg					i	4
		.......................
G	Channel,		Support		..............	I	2	I
H	Stiffener,		Side			t	2	I
J	Stiffener,		End			I	2
K	Support,		Motor			I	1
					...............
HARDWARE		FOR		MOUNTING		TOOL & MOTOR
CA	Lockwasher			Ext.	5/16
	Nut, Hex 5/16-18				..............

*Washer 11/32 ID ..............

*Bolt, Carriage 5/16-18 x 3/4 .......

*Parts Contained In Loose Parts Bag Part No. 69097

ABC

F_

gN

D

N

assembBy

ASSEMBLING STEEL LEGS

1.Assemble the two (2) End Stiffeners and the two (2)

Side Stiffeners using four (4) 1/4-20 Truss head screws.

The End Stiffeners are placed on top of each Side Stiffener as shown. Insert screws through the 9/32 inch diameter holes and attach Iockwashers and 1/4-20 nuts and finger tighten nuts.

2.Attach the four (4) legs to the Side and End Stiffeners using 1/4-20 screws, Iockwashers and nuts as shown.

3.Remove the four (4) Truss head screws which were assembled in Paragraph No. One. Place the two (2) Support Channels as shown, in position, align holes in supports with holes in the Stiffeners, replace Iockwashers and nuts. Tighten all nuts using 7/16" wrench.

4.Assemble the motor support to steel legs with 1/4-20

screws and nuts. Motor support can be mounted to either end of stand. Tighten nuts.

5.Install leveling feet as shown. To level Leg Set, loosen nut on inside of leg and turn nut on outside to raise or lower feet. Adjust all four levelers, if necessary, and then tighten nuts on inside of leg.

NOTE: These levelers are not intended for height acF justment,

		HEX NUT	LOCKWASHER
SCREW		"_	® _f	._j_/-	END
					STIFFENER
STIFFENER
SIDE		!	SIDE STI FFENER
STIFFENER		]		..jJ
CHANNEL	__				;
SUPPORT _		I _		CHANNEL
LOC KWASH ER -._.___				SUPPORT
HEX NUT	_				LEG
		l			I/4-20
SCR EW_°_		LEGS_f"			t
					REW
LEG _		I
		SCREW
					MOTOR
					SUPPORT
				LOCK_/ASHE	R

LEVELING

FEET "_"-_...._ ,_ HEX NUT