CRAFTSMAN 12-iNCH BAND SAW/SANDER, MODEL 113.243300 & 113.243311
NOTE:
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS REPAIR IS DONE BY QUALIFIED
SERVICE TECHNICIAN.
REPAIR SERVICE IS AVAILABLE
AT YOUR NEAREST SEARS STORE.
3
\
\
\
@-
FIGURE 4-- MOTOR PART NO. 69183
SUPPLIED WiTH MODEL 113.243311 ONLY
Key | Part |
|
|
|
|
No. | No. |
|
| Description | |
| 60306 | Screw, | Thread | ||
|
| Cutting, | Slotted, | Serrated | |
|
| Hd. |
|
|
|
| 64088 | Cover, | Terminal |
| |
| 64258 | Cord | with | Plug |
|
TERMINAL
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
1.Open motor connector box cover located on left end of motor (viewed from rear of saw) using a flat blade screwdriver.
2.Remove GREEN SCREW and Iockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with tockwasher between terminal and motor frame. (See illus.)
3.Reinsert GREEN SCREW in the threaded hole. Tighten securely.
GREEN
iNTERNAL'
LOCKWASHER
GREEN WIRE
4. | Insert | terminal | end | of WHITE | wire | on spade | terminal |
| |||||
| marked | T4 | on | the | motor. | Push | terminal | firmly | until | STRAIN RELIEF | |||
| seated. |
|
|
|
|
|
|
|
|
|
|
| pOVE |
5. | Insert | terminal | end | of BLACK | wire | on spade | terminal | TO | |||||
| marked | T1 | on | the | motor. | Push | terminal | firmly | until | TERMINAL T4 | |||
|
| ||||||||||||
seated.
6.Close motor connector box being sure that power cord is seated in the largest strain relief groove, and tighten box cover screws.
29
