assem61y

7.Install the small pulley ontothe motor shaft and tighten the se_ screw _n the pulley hub against the flat part of the motor shaft,

8.Push V-Belt partly through belt guard enough to allow belt to loop around the large pulley and push guard ove r belt and pulley into position on guard support

-1

\

OPEN END

9.Push the lower section of the V-Belt through theother guard as in the previous step and loop V-Belt around small pulley on motor shaft,

10.Visually line up both pulleys and V-Belt until they are

perpendicular to the floor by sliding motor sideways as needed.

11. Press clown hard on motor to put tension on the V-Bell

and tighten the motor mounting bolts at this time.

12, Check guard support before tightening guard support screws to be su re tt is centered around motor shaft and will not rub against shaft when motor =s running Tighten screws.

13.Push motor pulley belt guard into position onto guard support.

SMALL [2-9/2" DIA,) MOTOR PULLEY

5/32 INCH

TIGHTEN

SETSCREW

SET

SCREW

WRENCH

AGAINST FLAT

\

 

 

\

ON

SHAFT

\

/

PULLEY FLUSH

HERE WITH

MOTOR SHAFT

/

/

,/

I

SAW --

PULLEYS AND V-BELT

MUST BE STRAIGHT IN-LINE

_AT90' WITH RELATIONSHIP

TO THE FLOOR

 

_V-BELT

 

 

---7

 

!

t

GUARDS REMOVED

 

 

"_ _ FOR PICTURE CLARITY

\\'

\t

 

i/

,_

_

STRAIGHT LINE

 

#

\

UP --DOWN

 

I

 

 

 

t

90°

I

_ /

 

 

 

10

Page 10
Image 10
Sears 113.2433 manual Small 2-9/2 DIA, Motor Pulley, Setscrew, Wrench, Pulley Flush, Motor Shaft, Guards Removed