USING THE WEIGHT RESTS AND SAFETY SPOTTERS
Before beginning an exercise, insert the Weight Rests (21, 66) and the Safety Spotters (63, 69) into the holes in the Uprights (1, 2) that are best suited for the exer- cise. The selected holes should be at the lowest point to which you want your barbell to go during the exercise. Perform the exercise as shown in the accompanying exercise manual. Note: Make sure that the locking clips are hooked around the Uprights.
Important: The Safety Spotters (63, 69) are designed to minimize the risk of injury if the barbell is dropped during standing exercises. The Safety Spotters are deliberately designed to bend when hit with a barbell loaded with heavy weights. This minimizes the risk of the barbell bouncing off the Safety Spotters and causing injury to the user. If you accidentally bend the Safety Spotters, please call our Customer Service Department (see the front cover of this manual) to order replacement Safety Spotters.
WARNING: Always set both weight rests and both safety spotters at the same height.
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (18), slide the desired amount of weight (not included) onto the weight tube. Secure the weights with a Weight Clip (50).
WARNING: Do not place more than 150 pounds on the Leg Lever. Always secure the weights (not included) with a Weight Clip (50).
2 |
|
21 |
|
Locking Clips | 1 |
| |
| 66 |
| 69 |
63 |
|
| 18 |
Weight Tube
50
ADJUSTING THE FOAM PADS
The Foam Pads (10) inserted into the bracket on the Front Leg (19) can be adjusted to two different positions. To do this, pull one Foam Pad off the Pad Tube (38). Move the Pad Tube to the other hole in the bracket on the Front Leg. Push the Foam Pad back onto the Pad Tube.
14
Bracket |
38 |
10 |
19 |