4.Snap a Carriage Bushing (56) into the Weight Stop (53). Slide both parts onto the Rear Upright (9), mak- ing sure that the Carriage Bushing (56) is on top. Attach the parts to the indicated hole in the Rear Upright with an M8 x 68mm Bolt (60) and an M8 Nylon Locknut (13).
Next, slide the Rear Upright (9) onto the Right Stabilizer (26). Make sure that the Rear Upright is turned so the upper end slants in the direction shown. Attach the Rear Upright with an M10 x 65mm Bolt (67), two M10 Washers (6), and an M10 Nylon Locknut (11). Do not tighten the Nylon Locknut yet.
5.Press Carriage Bushings (56) into the top and bottom of the Weight Carriage (47).
Press a 48mm Round Inner Cap (12) into each end of the weight tube on the Weight Carriage (47).
Identify the Upper Cable (45); this is the longest of the two Cables. Note that the Cable has a ball/loop on one end and a loop on the other end. Attach the end with the loop to the indicated bracket on the Weight Carriage (47) with an M10 x 19mm Bolt (57) and an M10 Nylon Locknut (11). Make sure the Bolt is inserted from the direction shown.
Slide the Weight Carriage (47) onto the Rear Upright
(9).
6.Press a 2Ó Square Inner Cap (17) into the open end of the Top Frame (7).
Place the Top Frame (7) onto the Right Upright (2) and the Rear Upright (9).
Attach the Top Frame (7) to the Right Upright (2) with an M10 x 65mm Bolt (67), two M10 Washers (6) and an M10 Nylon Locknut (11). Attach the Top Frame to the Rear Upright (9) in the same manner.
8
4 | 60 |
| 9 | High | Low |
|
|
| hole | Side | Side |
|
|
|
|
| |
| 67 |
| 13 |
| 9 |
|
|
|
| ||
| 6 |
|
|
| |
|
|
|
|
| |
| 56 | 6 |
|
|
|
| 53 | 11 |
|
| |
|
|
|
|
| |
|
| 26 |
|
|
|
5 |
| 45 |
|
|
|
|
|
|
|
| |
|
| 11 |
|
|
|
| 12 |
|
| 56 |
|
|
|
|
|
| |
|
|
|
|
| 57 |
|
| 47 |
|
|
|
|
|
|
|
| 12 |
|
|
|
| 56 |
|
|
| 9 |
|
|
|
6 |
|
|
|
| 17 |
7 |
|
|
|
| 6 |
| 67 |
|
67 |
| 6 |
|
| |
| 6 | 11 |
|
| |
2 | 11 | 9 |