7.The Upper Cable (45) was attached to the Weight Carriage in step 5. Wrap the Upper Cable around a Pulley (35) in the direction shown.
Attach the Pulley (35) and a Cable Trap (61) to the indicated hole in the Top Frame (7) with an M10 x 108mm Bolt (34), a 15.8mm Spacer (31), an M10 Washer (6) and an M10 Nylon Locknut (11). Make sure the Cable Trap is oriented as shown, so it will hold the Cable in place.
8.Note: If the Pulley Plates (62) are
Wrap the Upper Cable (45) around a Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (61) to the upper holes in the two Pulley Plates (62). Note: Make sure that both Pulley Plates are oriented as shown, so the ends with several holes are pointed towards the floor. Attach the Pulley with an M10 x 48mm Bolt (55) and an M10 Nylon Locknut (11). Make sure the Cable Trap is oriented as shown.
9.Wrap the Upper Cable (45) around a Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (61) to the indicated hole in the Top Frame (7) with an M10 x 108mm Bolt (34), a 15.8mm Spacer (31), an M10 Washer (6) and an M10 Nylon Locknut (11). Make sure the Cable Trap is oriented as shown.
10.Route the Upper Cable (45) over a Pulley (35) in the direction shown. Attach the Pulley to the indicated hole in the Top Frame (7) with an M10 x 108mm Bolt (34), a 15.8mm Spacer (31), an M10 Washer (6) and an M10 Nylon Locknut (11). Make sure the Cable is between the Pulley and the welded pin (not visi- ble) on the Top Frame.
7 | 61 |
|
|
|
|
|
|
| |
34 |
|
|
|
|
| 35 |
|
| 31 |
|
|
|
| |
|
|
|
| 6 |
7 |
|
|
|
|
|
|
|
| 11 |
| 45 |
|
|
|
8 |
|
|
|
|
|
|
|
| 45 |
55 |
|
|
|
|
|
|
|
| 35 |
|
|
|
| 61 |
|
|
|
| 11 |
|
| 62 |
| Holes |
|
|
|
| |
9 | 61 |
|
|
|
|
|
|
| |
34 |
|
|
|
|
|
|
| 31 | 7 |
|
|
|
| |
35 |
|
|
| |
45 |
|
|
| 6 |
|
|
|
| 11 |
10 |
|
|
|
|
34 | 35 |
|
| 7 |
|
|
| ||
|
| 31 |
|
|
45 |
|
|
|
|
Welded | 6 |
|
| |
11 |
|
| ||
| Pin |
|
| |
|
|
|
| |
9