Image IMST90060 user manual Assembly, Screwdriver A rubber mallet

Page 4

ASSEMBLY

Assembly requires two people. Place all parts of the stepper in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning.

THE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The included allen wrench

, a phillips

screwdriver

, and a rubber mallet

.

 

1.Feed the end of the console wire harness down through the Upright (2). Attach the Console (50) to the Upright with four #8 x 1/2Ó Screws (25). Be careful to avoid pinching the console wire harness.

2.Remove the five indicated #8 x 1/2Ó Screws (25) from the Right Side Shield (55). Remove the five corresponding #8 x 1/2Ó Screws from the Left Side Shield (62). Do not remove the Side Shields.

3.While another person holds the Upright (2), connect the console wire harness to the Lower Wire Harness (32). Refer to the inset drawing. If the Wire Harnesses do not fit together easily, turn themÑdo not force them together.

Tip the Side Shields (55, 62) forward. If the three M10x 25mm Button Screws (49) and M10 Lock Washers (20) are in the Frame (1), remove them. Feed the Wire Harness (32) into the Frame, and slide the Upright (2) onto the Frame. Loosely thread the three M10 x 25mm Button Screws with M10 Lock Washers into the Upright and the Frame. After you have threaded all three Button Screws into the Upright and the Frame, firmly tighten them.

Tip the Side Shields (55, 62) back and reattach them with the

ten #8 x 1/2Ó Screws (25) removed in step 2. Install the bottom

4Screws first.

1

 

50

 

2

 

 

25

 

Console

 

Wire Harness

2

 

62

55

 

 

25

 

25

3

2

 

49

20

20

 

Console

49

 

Wire Harness

55,62

32

 

1

 

Image 4
Contents Model No. IMST90060 Serial No QUESTIONS?Customer HOT Line Table of Contents Important PrecautionsBefore YOU Begin FrontRight Side BackAssembly Screwdriver A rubber malletPage HOW to USE the IMAGE¨ 7.0 Stepper Diagram of the ConsoleHOW to USE the Manual Mode HOW to Exercise on the StepperHOW to USE the Workout Programs TROUBLE-SHOOTING and Maintenance Information ModeHOW to Adjust the Reed Switch Start the programHOW to Measure Your Heart Rate Conditioning GuidelinesExercise Intensity Unconditioned Conditioned Training Zone BEATS/MIN AGETraining Zone Exercise Exercise FrequencyCooling Down Key Qty DescriptionExploded Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT