Image IMTL39620 user manual Assembly, Driver Adjustable wrench Wire cutters

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-

driver	, adjustable wrench	, wire cutters	, and needlenose
pliers	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

To identify small parts during assembly, use the part identification drawings below.

1 1/2” Screw (79)–4	3/4” Screw (68)–2	3/4” Tek Screw	Silver Screw
		(101)–5	(107)–1
	4” Bolt (89)–4
	Wheel Bolt (86)–2		Washer (29)–8
	3” Bolt (47)–4		Wheel Nut (15)–2

1.Make sure that the power cord is not plugged in.

With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (12) so that the treadmill will be more stable. Do not fully fold the treadmill until it is completely assembled.

Attach two Base Pads (97) to the bottom of the Base (82) with two 3/4” Tek Screws (101). Attach a Wheel (95) to the outside of the Base with a Wheel Bolt (86) and a Wheel Nut (15).

1	101	86
	97
	82	95
		101
		97
		15
		12

6