Polycom RMX 2000 Hardware Guide
Operating Mode Selection During Startup / Restart
When started with Version 7.x installed, the RMX enters MPMx Mode by default when no media cards are installed.
•The RMX switches between MPM, MPM+ and MPMx Card Configuration Modes when MPM/MPM+/MPMx cards are removed or swapped while the system is running.
•The switch between Card Configuration Modes occurs during the next restart.
•Installing or swapping MPM/MPM+/MPMx cards while the system is off will not cause a switch in the Card Configuration Mode when the system is restarted – it will restart in the Card Configuration Mode that was active previous to powering down.
System Information Changes
The System Information includes License Information, and general system information, such as system memory size and Media Card Configuration Mode, which in version 7.0 includes the MPMx Mode.
Table 6 summarizes the Operating Mode After Next Restart resulting from of adding or swapping MPM/MPM+/MPMx cards in a running system.
Table 6 RMX Card Configuration Mode After Next Restart
Current | Media | Card(s) | Card(s) | Operating | |
Operating | Cards | Mode After | |||
Supported | Disabled | ||||
Mode | Installed | Next Restart | |||
|
| ||||
|
|
|
|
| |
| MPM | None | All | MPM | |
|
|
|
|
| |
| MPM+ | None | All | MPM+ | |
|
|
|
|
| |
MPMx | MPM and | MPMx Only | MPM | MPMx | |
| MPMx | ||||
|
|
|
| ||
|
|
|
|
| |
| MPM+ and | MPMx Only | MPM+ | MPMx | |
| MPMx | ||||
|
|
|
| ||
|
|
|
|
|
