Assembly
FIGURE 4:
Step 1:
Thread the right pedal (39) onto the right side of the crank (8) as shown. Tighten the pedal securely. Select the right pedal strap which has “R” marked on the bottom side of the strap. Snap the three hole end onto the inside edge of the right pedal (39). Snap the other three hole end onto the outside edge of the right pedal (39). Select adjustment holes which allow your foot to be easily removed from the pedals.
Step 2:
Repeat with the left pedal and strap.
FIGURE 5
Step 1:
Insert the sensor wire (packed with ten- sion controller) from the top of the han- dlebar post (75). Connect the wires per Figure 5.
Step 2:
Fix the handlebar post (75) onto the main frame (1) with screws (49) and arc wash- ers (36).
Figure 4 |
|
| 38 |
| 8 |
| 1 |
| 39 |
Figure 5 | 75 |
|
FIGURE 6
Step 1:
Connect Tension Knob (30) to Resistance Cable (58). Refer to Figure 6a,6b,and 6c for detailed instructions. Using one Screw
(65)attach Tension Knob to Upright Post Assembly (77).
Figure 6
7