Assembly
FIGURE 6a, 6b,6c: Connect the Tension Knob to the Resistance Cable. Fit the Resistance Control Cable into the slot of the Tension Knob. Pull the brass end of the Resistance Control Cable over the lip of the Tension Knob Bracket. The connection should look like Figure 6c when completed.
6a
6b
6c
FIGURE 7:
Step 1:
Connect Sensor and Tension Cables to Console as shown is Figure 7.
Step 2:
Attach Console (33) to Upright using four Screws. Note: The four Screws will already be installed into the back of Console(33) when you remove it from the box.
Figure 7 |
CONGRATULATIONS!!!!!!
You have completed Assembly of your New Ironman 120r Recumbent.
8