ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
STEP 3
Attach left arm (4) to shaft (26) using one (49) allen screw (make sure to allow the allen screw to align with the hole in the shaft (26)). This will need to be repeated with the right arm (5) once both arms are connected. Connect left arm (4) and right arm (5) using:
4 x (60) Nylon locknut M12
4 x (55) Wahser 12
2 x (11) Bolt shaft M12 x 300
2 x (12) Spacer tube
2 x (49) Allen screw
Both allen screws (49) will need to be aligned with the holes in the shaft and tightened before put- ting the end caps (33) onto each arm.
Insert the brake cable end into the brake handle groove and then connect brake handle (20) to the
left arm using : |
|
1 x (42) Bolt | 1 x (58) Nylon locknut M6 |
Back Side
Z