4
English
SPECIFICATIONS
POWER TOOL
STANDARD ACCESSORIES
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (FEB9S) (For FDS9DVA)
2. Battery (FEB12S) (For FDS12DVA)
Optional accessories are subject to change without notice.
Model FDS9DVA FDS12DVA
No-load speed (Low/High) 0–280 / 0 –840/min. 0–350 / 0 –1050/min.
Wood
Drilling
(Thickness 18mm)
18 mm 21 mm
Metal Steel: 10 mm, Steel: 12 mm,
(Thickness 1.6mm)
Aluminum: 12 mm Aluminum: 15 mm
Machine screw 6 mm 6 mm
Driving Wood screw
5.5 mm (diameter) × 45 mm (length) 5.5 mm (diameter) × 63 mm (length)
(Requires a pilot hole) (Requires a pilot hole)
Rechargeable battery FEB9S: Ni-Cd 9.6 V FEB12S: Ni-Cd 12 V
Weight 1.5 kg 1.6 kg
Capacity
CHARGER
Model UC9SD UC12SD
Charging time Approx. 1 hour (at 20°C)
Charging voltage 9.6 V 12 V
Gewicht 1.2 kg 1.4 kg
1Plus driver bit (No. 2⳯55L)........ 1
FDS9DVA 2Charger (UC9SD)............................ 1
3Plastic case....................................... 1
1Plus driver bit (No. 2⳯55L)........ 1
FDS12DVA 2Charger (UC12SD)........................... 1
3Plastic case....................................... 1
APPLICATIONS
䡬Driving and removing of machine screws, wood
screws, tapping screws, etc.
䡬Drilling of various metals.
䡬Drilling of various woods.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 20°C. The pilot lamp goes
off to indicate that the battery is fully charged.