GE Monogram ZISB42D Custom Panel Dimensions, Built-In Refrigerator, ZISW42D white dispenser

Custom Panel Dimensions

42" Built-In Refrigerator

Custom Door Panel Dimensions

ZISW42D (white dispenser)

Using Trim Kit ZKT42

ZISB42D (black dispenser)

3/4" thick panel with custom handle

• ZKT42 and ZKHT1 installed together provides for the

and/or ZWCD1 custom collar trim

installation of 3/4" custom door and grille panels, using

a custom handle of your choice. Cut panels to size, rout

Freezer Panel

Freezer Panel

the handle side of the panels as shown below and install

(see detail B).

Standard

Custom

Fresh Food

• For ZKHTSS1 tubular stainless steel handle kit, cut panels

Dispenser

Dispenser

Panel

to size and rout the handle side of the panels as shown in

detail B.

• For standard dispenser trim: Cut panels to size, rout the

16 11/16"

17 11/16"

handle side of the panels as shown in detail B, rout the

bottom of the upper freezer panel and the top of the lower

freezer panel to allow placement of support brackets (see

67 15/16"

detail A) and install.

• For custom dispenser trim ZWCD1 kit must be used: Cut

2 9/16"

panels to size, refer to detail C for dispenser cutout

routing instructions. When a raised panel design is used,

a custom middle rail is required. A 14-1/2" wide middle rail

37"

must be used because the custom collar trim must be

located within the raised portion of the panel. This area

must be 3/4" thick. See detail D for raised panel design

requirements.

• When using the standard full-width dispenser trim, the

length of the custom handle, top to bottom cannot exceed

15 5/16"

15 5/16"

25 5/16"

11-3/4". Locate the handle a minimum of 3/4" and a

maximum of 1-1/2" from the edge of the panel. There are

no length restrictions on handles for models using a

Important: Maximum weight for fresh food panels is

custom collar dispenser trim (ZWCD1).

50 pounds and 30 pounds for freezer door panels.

Custom Grille Panel

Detail A

41 1/2"

Upper

Detail B

Freezer

Rout panels to specification below on

Panel

the handle side of each panel

A

Over 1/4" Thick (3/4" max) Panel

1 13/16"

1 13/16"

Grille Panel height can vary to fill installation

1"

height.

3/32"

Installation Height

Dimension A

1/4"

83"

8-1/4"

1"

Freezer Door Face

Fresh Food Door Face

83-1/2"

8-3/4"

max

84"

9-1/4"

Panel

84-1/2"

9-3/4"

Face

Detail C Custom		Important: Maintain 1-1/2" min. gap between
Dispenser Cutout		top of doors and bottom of grille panel.
Lower
Freezer			Detail D
Panel		Raised Panel Design
9 7/16"		*3" Stiles	*2-3/16" Stiles
		Left Side	Right Side
	7/8"	A	Hole is Cut
12 5/16"	Wide
	Rout		After Door
			Fabrication
		A		14 1/2"
The Cutout is 9 7/16" wide				Wide
by 12 5/16" high. 3/4" panels				Middle
must be routed on all four				Rail
sides of the cutout. Rout			Handle
the back side of the panel			Side
1/4" deep. 7/8" wide
(shaded area).		*Custom Stiles and		Section AA
		Middle Rail Required

CUSTOM PANEL DIMENSIONS

13