GE Monogram ZIS42N, ZISB42D Re-install dispenser trim, temporarily, Step Locate Position Handle

ZKH1 Trim Kit (For 1/4" Panels)

Support for Custom Handles

ZKH1 INSTALLATION

OPTION 2

For dispenser model using full-width trim

Step 1

Remove handles

Step 2

Remove trim

• Open door to 90°. Remove the screws from the full-length aluminum handle of the freezer door.

• Retain screws, discard handle.

Remove door panel trim above and below dispenser.

Lift off dispenser trim. Retain screws and trim.

Remove

Trim

Remove

Dispenser Trim

Step 3

Locate

position

of handle

•Position the handle bracket onto the steel door by matching existing screw holes on the door and bracket. Temporary secure with screws.

•Re-install dispenser trim, temporarily.

•Determine the desired location of the custom handle and carefully mark centerlines of the screw holes.

•Drill 1/16" pilot hole through the trim until it

starts into the handle bracket. This will mark the matching location for drilling a clearance hole when assembling the handle, bracket and dispenser trim.

•Remove dispenser trim and bracket.

Temporarily Temporarily

Secure Secure

Handle Dispenser

Bracket Trim

With With

Screws Screws

24