GE Monogram ZIS42N, ZISB42D Prudence, Installation, Built-In Refrigerator, Use of Adapter plug

Tools Required

Hardware Supplied

Materials Required

Flooring

Installation

		42" Built-In Refrigerator
• Tinsnips to cut banding	• Bucket	• 7/16" open-end wrench	• Drill and appropriate
• Stepladder	• Level	• #2 Phillips screwdriver	bits
• 1-1/2" open-end wrench	• Appliance Hand Truck	• Stubby Phillips	• 7/16" socket with 3"
	• Tubing cutter	screwdriver	extension for ratchet
			• Safety glasses
• Special velcro adhesive	• 1/4-1/4 union with nuts
strips for 1/4" side	• 1/4" panel foam spacers
panels
				PRODUCT INSTALLATION
• Water shut-off valve (optional but recommended)		• Side panels
• Custom panels for fresh food, freezer compartments,		• Hardware for side panel installation.
grille panel		• 42" long 2x4 for Anti-Tip support
For proper installation, this refrigerator must be placed		NOTE: Protect the finish of the flooring. Cut a large
on a level surface of hard material that is at the same		section of the cardboard carton and place under the
height as the rest of the flooring. This surface should be		refrigerator where you are working.
strong enough to support a fully loaded refrigerator.

Grounding the Refrigerator

IMPORTANT - (Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

Use of Adapter plug

Because of potential hazards under certain conditions, we strongly recommend against use of an adapter plug. However, if you still elect to use an adapter, where local codes permit, a TEMPORARY CONNECTION, may be made to a properly grounded 2-prong wall outlet by use of a UL listed adapter available at most hardware stores.

The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord.

CAUTION

Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

When disconnecting the power cord from the adapter, always hold the adapter in place with one hand and pulling the power cord with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.

Should the adapter ground terminal break, DO NOT USE the appliance until a proper ground has again been established.

Use of Extension Cords

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts.

PRUDENCE

FICHE D’ADAPTATION

(Fiches d’adaptation non permises au Canada)

15