GE Monogram ZISB42D ZKH1 Trim Kit For 1/4 Panels, Support for Custom Handles, 3/4 Min 1-1/2 Max

ZKH1 Trim Kit (For 1/4" Panels)

Support for Custom Handles

Option 1 Installation

Step 2	Door Extrusion
Locate position
of handles

INSTALLATION

ZKH1

3/4" Min.

1-1/2" Max.

Note: Handle must be located 3/4" to 1-1/2" from edge of extrusion.

•Slide custom panels into fresh food and freezer door frames.

•Temporarily secure the new door extrusions to the doors. Use at least 2 screws on each door.

•The handles must be located 3/4" to 1-1/2" from the edge of the extrusion.

•Determine the desired location of the custom handles and carefully mark centerlines of the screw holes.

•Again, with both doors closed, check the location of the centerlines to be sure they are parallel to the edge of the door, and level with opposite door.

•Drill 1/16" pilot hole through the panel until it starts into the aluminum extrusion. This will mark the matching location for drilling the clearance hole when assem- bling the handle, panel and extrusion.

22